Hardware: Hive Interface Board 1.0

From HiveTool
Revision as of 02:52, 30 May 2018 by Paul (talk | contribs)
Jump to: navigation, search

Ver 1.0 of the Hive Interface Board. As suggested by the 1.0 designation, this is considered to be "done" and should be the final release of this design.


  • Add Real Time Clock (RTC) support so DS3231 will plug into header H2 without modification.
  • Change 1-Wire connection to Pi's default 1-Wire GPIO by swapping GPIO pin for LED from pin 7 (default 1-wire) to pin 11.
  • Added Chip Enable signal to SPI bus signals on H7.
  • Increase hole size for blue 12 VDC power connector from .038" to .042".