Difference between revisions of "Sensors: Rain Gauge"

From HiveTool
Jump to: navigation, search
(Created page with " ==Rain Gauge== ===Tipping Bucket Rain Gauge=== These have a bucket with two compartments that tips when one fills up which dumps the full bucket, starts filling the other bu...")
 
(Connection to the Hive Interface baord)
Line 21: Line 21:
 
Red    GPIO XXX
 
Red    GPIO XXX
  
==Connection to the Hive Interface baord==
+
===Connection to the Hive Interface baord===
 
 
 
Plug the RJ11 into the proper RJ11 jack on the Hive Interface Board.
 
Plug the RJ11 into the proper RJ11 jack on the Hive Interface Board.
  

Revision as of 04:16, 9 March 2020

Rain Gauge

Tipping Bucket Rain Gauge

These have a bucket with two compartments that tips when one fills up which dumps the full bucket, starts filling the other bucket. As the bucket tips, a magnet swings by a magnetic read switch and briefly closes the contacts. The switch is connected between ground and one of the Pi GPIO line XXX. The PIGPIOD daemon/library monitors this GPIO line.


Models

Rainwise


http://www.misolie.net/misol-spare-part-for-weather-station-to-measure-the-rain-volume-for-rain-meter-for-rain-gauge-p-513.html <http://www.misolie.net/misol-spare-part-for-weather-station-to-measure-the-rain-volume-for-rain-meter-for-rain-gauge-p-513.html>

Wiring

Properly terminated RJ11 cable connect the rain gauge to the Yellow and Red wires.


Yellow Ground Red GPIO XXX

Connection to the Hive Interface baord

Plug the RJ11 into the proper RJ11 jack on the Hive Interface Board.


Turn on the Rain Gauge in the Configuration Page

Calibration