Difference between revisions of "Sensors: DHT22"

From HiveTool
Jump to: navigation, search
Line 1: Line 1:
 
[[File:Dht22 wiring1.jpg|thumb|right|500px|Left: DHT22 from Adafruit mounted on PCB with pull up and bypass capacitor.<br>Right: Bare sensor from EBay without pull up or bypass.]]
 
[[File:Dht22 wiring1.jpg|thumb|right|500px|Left: DHT22 from Adafruit mounted on PCB with pull up and bypass capacitor.<br>Right: Bare sensor from EBay without pull up or bypass.]]
 +
[[File:Wired dht22c.jpg|thumb|right|500px|Wired DHT22 '''WARNING''' wire color code is different. Red: +5, Black: Ground, Yellow: Signal]]
 +
 
The AM2302 (DHT22) is a 3 wire (Vcc, data, gnd) temperature and humidity sensor manufactured by Aosong.
 
The AM2302 (DHT22) is a 3 wire (Vcc, data, gnd) temperature and humidity sensor manufactured by Aosong.
  

Revision as of 01:32, 14 April 2016

Left: DHT22 from Adafruit mounted on PCB with pull up and bypass capacitor.
Right: Bare sensor from EBay without pull up or bypass.
Wired DHT22 WARNING wire color code is different. Red: +5, Black: Ground, Yellow: Signal

The AM2302 (DHT22) is a 3 wire (Vcc, data, gnd) temperature and humidity sensor manufactured by Aosong.

Spec Sheets

AM2302 spec sheet
New AM2302/DHT22 spec sheet

Test Results

http://www.kandrsmith.org/RJS/Misc/calib_dht22.html


Pull Up Resistor

The Adafruit module (left) includes a 5.1K pull up resistor and a bypass capacitor.

The Pi does have internal pull ups that are turned on. They are about 50K. Our tests on 3 meter cables did not show any significant difference in performance or read errors whether or not the 5.1K pull up or bypass capacitor was used. However, good engineering practices would use the pull up and bypass cap.

The new DHT22 spec sheet shows the pull up value as 1K in Figure 5. The old spec sheet said: "single bus usually require an external about 5.1kΩ pull-up resistor."

Read Time

You must wait at least 2 seconds before reading again or you will get a bad read (the checksum will fail).

The new spec sheet: "the interval of whole process must beyond 2 seconds."

The old spec sheet:

3.Read the sensor minimum time interval for the 2S; read interval is less than 2S, may cause the temperature and humidity are not allowed or communication is unsuccessful, etc.. 4.Temperature and humidity values are each read out the results of the last measurement For real-time data that need continuous read twice, we recommend repeatedly to read sensors, and each read sensor interval is greater than 2 seconds to obtain accurate data.

WARNING: The spec sheet refers to this a a "1-wire" device. This is not a 1-Wire bus trademarked by Dallas Semiconductor Corp. The later spec sheet has a disclaimer.