Difference between revisions of "GPIO Conflicts"
| Line 1: | Line 1: | ||
| + | ==Hive Interface Board== | ||
| + | |||
| + | If the sensors are not connected and the drivers are not enabled, there should be no conflict. | ||
| + | |||
| + | See [[GPIO_Pinout#GPIO_ordered_by_Header_Pins|GPIO Pinout]] for a table of the GPIO pins used by Hivetool sensors. | ||
| + | |||
==UPS PIco - Uninterruptible Power Supply== | ==UPS PIco - Uninterruptible Power Supply== | ||
Revision as of 20:25, 18 April 2019
Hive Interface Board
If the sensors are not connected and the drivers are not enabled, there should be no conflict.
See GPIO Pinout for a table of the GPIO pins used by Hivetool sensors.
UPS PIco - Uninterruptible Power Supply
UPS PIco - Uninterruptible Power Supply (HV3.0B+) conflicts with the DHT22s which are use GPIO27 (Pin13) & GPIO22 (Pin15).
The UPS PIco Uses the Following Pins
- Serial Port (Firmware Updates): GPIO14 (Pin8) & GPIO15 (Pin10)
- i2c Port: GPIO2 (Pin3) & GPIO3 (Pin5)
- Pulse Train: GPIO27 (Pin13) & GPIO22 (Pin15)
It also uses the I2C addresses 68-6f:
$ i2cdetect -y 1
0 1 2 3 4 5 6 7 8 9 a b c d e f
00: -- -- -- -- -- -- -- -- -- -- -- -- --
10: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
20: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
30: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
40: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
50: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
60: -- -- -- -- -- -- -- -- 68 69 6a 6b 6c 6d 6e 6f
70: -- -- -- -- -- -- -- --
Witty Pi Mini Realtime Clock and Power Management
Witty Pi Mini uses GPIO-4, GPIO-17, GPIO-2(SDA 1) and GPIO-3(SCL 1). The usage of GPIO-4 and GPIO-17 are customizable.
